Attaching Vinyl Siding To Concrete Wall

The strips can be ripped from 2 inch by 4 inch lumber or plywood but they should be at least 3 4 inch thick.

Attaching vinyl siding to concrete wall.

As a result the osb protrudes about a half inch farther out than the concrete. Although the process of installing vinyl siding is relatively simple it helps to have assistance. If so then tyvek it. I will have a 4 retaining wall for wing walls.

The vinyl siding that around the concrete portion that i want to cover up is attached to an osb board that s attached to the framing of the house. If you are installing furring strips over the concrete you better either 1 use treated material for this or 2 put tar paper between the cement and furring strip. This renders the siding vulnerable to moisture and voids the warranty even if you seal the hole. The basement walls are 8 poured concrete walls with the back wall being framed.

Using self tapping screws such as those by tapcon will fasten the strips to the concrete securely but concrete nails can be used as well. Installing vinyl siding over concrete is similar to installing it over wood since you have to install wooden furring strips under the siding. Vinyl siding unlike other types. There are at least three alternative ways to do it.

Vinyl siding can give an ordinary concrete home an appealing polished look and update its appearance. But if you want a garage that is both sturdy and attractive you may want to cover your garage s exterior concrete block wall surface with something more becoming than the concrete block. In effect i would need to add a bit of spacing between the concrete and the siding. Is there any wood exposure with the concrete wall.

Installing 2 inch wide treated strips is necessary for a solid base for the house siding. If you want to hang something from your vinyl siding don t even think about drilling through it to attach a hook to the sheathing. A concrete block garage is just about as sturdy as any garage can be. Use concrete screws to attach the boards to the block.

One choice might be vinyl siding. The concrete foundation is nearly flush with the first floor siding meaning that using furring strips would cause the new siding to stick out. The contractor proposed using tapcons to attach the siding directly to the foundation which would allow the siding to line up with the first floor. If you are useing a treated material for the fur strips then tyvek is pointless over concrete.